Alpinestars Tech-Air 3 Canvas Manual De Instrucciones página 27

WARNING! The System will be fully active (i.e. ready to deploy) only after
having started riding for approximately 10 seconds. Once activated,
the System will remain active even if the rider stops, and until
the System is manually switched off, to offer protection also in a
stationary condition in case the motorcycle is hit by another vehicle
as described in the Envelope of Protection conditions (see Section 3
"Tech-Air® Envelope of Protection").
WARNING! The user MUST ALWAYS check the LED Display (2) after the System
Check to confirm that the solid blue LED indicator is illuminated
before starting to ride/use the System. The System will not deploy
if the solid blue LED indicator is not present on the LED Display (2).
c) Switching Off the System
Turn the System off by opening the Activation Zip (1). The System will shut down after
approximately 1 second. Confirm that the System is off by checking that the LED Display
(2) is switched off. A long vibration (~3s) of the LED Display (2) will confirm that the System
is no longer activated.
To keep the System switched off, keep the Activation Zip (1) open as shown in Figure 10.
Always keep the System in this condition while stored, transported, or shipped (see Section
14 "Cleaning, Storage and Transportation").
WARNING! ALWAYS switch the System off by opening the Activation Zip (1) when
you are not riding a motorcycle, even if you continue to wear the
System. Although the System has been evaluated for a number of
non-riding activities, keeping the System switched on and/or active
increases the possibility of an unwanted deployment and drains the
battery. So as a rule, when not riding, always open the Activation
Zip (1).
28 EN