Alpinestars Tech-Air 3 Canvas Manual De Instrucciones página 49

19. Tech-Air® Support
In case of questions or should users need further information, they may contact the Tech-
Air® Dealer where they purchased the System or contact Alpinestars directly:
E-mail: techairsupport@alpinestars.com
Tel: +39 0423 5286 (ask for Tech-Air® Support)
20. Certification Information
The Tech-Air® 3 Canvas System is manufactured by:
Alpinestars SpA
5, Viale Fermi – Asolo (TV) 31011 Italy
And it is covered by a number of certifications.
Personal Protective Equipment
The Tech-Air® 3 Canvas System is considered Category II certified PPE (Personal Protective
Equipment) under European regulation (UE)Regulation 2016/425. This product in
compliance also under the corresponding UK legislation (Regulation 2016/425 on personal
protective equipment as applied in GB) law and amended. An EU Type examination has been
conducted on this product using the Notified Body.
As an impact protector garment, the standard EN 17092-6:2020 has been applied; as
motorcyclist inflatable protector, the certification has been achieved considering the
following standard:
• EN 1621-4:2013 Motorcyclists' protective clothing against mechanical impact – Part 4:
Motorcyclists' inflatable protectors – Requirements and test methods.
Any characteristics of the Device that could not be evaluated through the standard
mentioned above were analysed in consultation with the Notified Body.
The EU examination was conducted by:
Notified Body #2008 Dolomiticert S.C.A.R.L., Zona ind. Villanova 7/A, 32013 Longarone (BL),
Italy
The explanation of the product markings are as follows:
- Protective garments for Motorcycle Riders (EN 17092 – 6: 2020)
- Inflatable Impact Protector
50 EN