iTD uni-cart Instrucciones Para El Uso página 37

2.4 Risk of mechanical instability
2.5 Castors
2.6 Load capacity
2.7 Assembly / Handling
2.7.1 Shelves
Operating manual uni-cart, vexio-cart, pro-cart, duo-cart, compact-cart, classic-cart and endo-cart 03/2014
TD_JEST_15_GA_001 Rev.: 001
For transportation please refer to section 4 of this manual.
The overall system must be in accordance with IEC 60601-1.
The uni-cart, vexio-cart, pro-cart, duo-cart, compact-cart,
classic-cart or endo-cart carrier system has twin swivel
castors with brakes. You should check to see that the wheel
locks are working properly before using the uni-cart, vexio-cart,
pro-cart, duo-cart, compact-cart, classic-cart or endo-cart
carrier system. When parking the cart or stopping during
transport, all roller brakes on the equipment cart must be
pressed (roller locking device). Accordingly, all roller brakes
must be released before moving and transport.
The castor must be tested every 12 months for safety as well as the crackproof, firm hub of the
castor attachment pin. If these should be lost, please contact your supplier immediatly.
It is not permitted to exceed the load rating of the uni-cart, vexio-cart, pro-cart, duo-cart,
compact-cart, classic-cart or endo-cart carrier system.
You should observe the maximum load capacity of the uni-cart, vexio-cart, pro-cart, duo-cart,
compact-cart, classic-cart or endo-cart carrier system (see section 10 of these operating
instructions).
Shelves can be removed or installed in another position. Loosen the screws, re-position the
shelf and then screw the shelf tightly in position again. Check the safety-earth resistance.
Erstellt am/durch: 07.04.2015/ITD Freigabe am/durch: 07.04.2015/ETI
Assembly
35
Seite 37 von 128