iTD uni-cart Instrucciones Para El Uso página 44

Height adjustment
5 Mechanical and electrical height adjustement
42
TD_JEST_15_GA_001 Rev.: 001
Specific safety regulations must be observed for the „mechanical height adjustment" using the
„gas pressure", as well as for the electro-mechanical height adjustment using „Linear drive", in
accordance with IEC 60601-1 „Mechanical Risk in Conjunction with Moving Parts". Hereby:
• Take into consideration and adhere to the permitted distance between moving parts, in
accordance with IEC 60601-1 in Table 20 (ISO 13857:2008).
• Products with height adjustment are manufactured and supplied ex works conforming to the
standard, under consideration of the permitted safety distances. Due to the equipping of or
replacement with ME devices and / or component, these distances change. This can result
in a mechanical risk. The respective person who configures the system is responsible for
adhering to the minimum distances required.
• The overall weight of the devices and accessories installed must not exceed the specified
maximum overall payload of the height adjustment. Overloading results in damage to the
height adjustment and loss of the warranty.
• Stored energy is released with the mechanical height adjustment using gas pressure. Thereby,
for unloaded systems sudden, unbraked activation of the height adjustment can result in
injuries and damage.
o In order to prevent injuries and damage, before installation and removal of the devices,
place the height adjustment at the uppermost position („energy-free").
o The height adjustable supporting arm system „flexion-port" must also be fixed and
secured at the uppermost position („energy-free") with the aid of the clamping lever (refer
to the separate user instructions for the „flexion-port", as well as the risk notes on the
supporting arm system).
• Unintended activation of the electro-mechanical height adjustment using the manual button
can also result in injuries and damage.
o In order to prevent injuries and damage, before installation and removal of the devices,
disconnect the height adjustment from the power supply.
o Servicing and maintenance tasks in the „interior area" of the height adjustment, i.e. in the
covered area within the supporting column not accessible from outside, must only be
carried out by specialists.
o Caution: If operating the height adjustment using a remote control, make sure that no
persons are in the hazard area.
Erstellt am/durch: 07.04.2015/ITD Freigabe am/durch: 07.04.2015/ETI Seite 44 von 128