Status Signals - Ottobock Kenevo 3C60 Instrucciones De Uso

LED LED Battery char­
on on ger connected
power bat­ to product
sup­ tery
ply char­
ger
Yes
Beep signal
4 x short at intervals
of approx. 20 sec.
(continuously)

13.2.3 Status signals

Battery charger connected
LED on LED on
power battery
supply charger
Battery charger disconnected
Beep Vibration
signal signal
1 x short 1 x short
3 x short
Error
Distance between battery
charger and receiver of the
charging unit too big
No connection between bat­
tery charger and power sup­
ply
Defective battery charger
Error
Charging the battery outside the
allowable temperature range
Event
When connecting the power supply to the outlet, the LED on the battery
charger lights up briefly
Power supply and battery charger operational
Event
Self-test completed successfully. Product is operational.
Maintenance note
Conduct the self-test again by connecting/disconnecting the battery
charger. If the beep signal sounds again, you should visit your prosthet­
ist soon. If necessary, the prosthetist will forward the product to an
authorised Ottobock Service Centre.
The product can be used without restrictions. However, vibration signals
may not be generated.
Resolution
The distance between the
battery charger and the
receiver on the product must
not exceed 1 mm / 0.04 inch
Check whether the charging
cable plug is fully engaged
on the battery charger.
The charger and the power
supply must be inspected by
a prosthetist.
Resolution
Check whether the specified ambi­
ent conditions for charging the bat­
tery are met (see Page 60).
65