Beurer ANTELOPE Corefit I Instrucciones De Uso página 19

*The frequency
The frequency determines how often an electri-
cal pulse occurs within a certain period of time.
In turn, this determines how often individual
muscle fibres contract. You cannot change this
value in the Antelope programs.
*The pulse length (pulse duration)
The pulse length or pulse duration denotes the
time during which electrical pulses flow into the
muscles. The longer this time is, the more inten-
sively and deeply the muscles will be trained.
*Duty cycle
The stimulation interval, also known as the duty
cycle, determines the ratio between the stimu-
lation phases and pauses during a training ses-
sion. Some EMS programs require these pauses
for your muscles.
Programs with a duty cycle
Some programs require a stimulation interval.
This could be as follows:
Example: You select a program with the duty
cycle "4 sec ON, 4 sec OFF". As such, it will run
at a repeating interval of four seconds of stimu-
lation and four seconds of pause.
One stimulation interval
Ein Stimulationsintervall
PULSE
IMPULS
(duty cycle) (Duty Cycle)
4S ON 4S ON
4S OFF
EXAMPLE
BEISPIEL
ON TIME = 4 seconds stimulation phase
ON TIME = 4 Sekunden Stimulationsphase
OFF TIME = 4 seconds stimulation pause OFF TIME = 4 Sekunden Stimulationspause
Programs without a duty cycle
Some programs do not have a duty cycle. In
such cases, your muscles will be continuously
stimulated.
4S ON
4S OFF 4S OFF
TIME ZEIT
PULSE
IMPULS
ON
ON
ON TIME = constant and continuous ON TIME = konstant und durchgängig
9. CLEANING AND
MAINTENANCE
• Always remove the batteries from the device
before cleaning.
• Clean the device with a slightly damp cloth.
If it is very dirty, you can also moisten the
cloth with a mild soapy solution.
• Do not drop the device.
• Ensure that no water enters the device. If
this happens, only use the device again once
it has fully dried out.
• Do not use any chemical or abrasive clean-
ing agents for cleaning.
• The belt is not machine-washable. Once
you have removed the device (control unit)
from the belt, you can wipe down the belt
with lukewarm water. Use a mild soapy solu-
tion or liquid detergent for this. Do not use
bleach.
10. ACCESSORIES AND
REPLACEMENT PARTS
To purchase accessories and replacement
parts, please visit www.beurer.com or contact
the corresponding service address (according
to the service address list) in your country. Ac-
cessories and replacement parts are also avail-
able from retailers.
Designation
Accessory set,
comprising:
• 2x adhesive electrodes
(45 x 45 mm)
• 1x connection cable
• 1x quick guide
19
TIME ZEIT
Item number
and/or order
number
Article 647.05