Suzuki DF100A Manual Del Propietário página 20

3. Make sure that remote control handle is in
"NEUTRAL".
"NEUTRAL"
4. Using the throttle only function of the remote
control box, move the warm-up lever upward
until the caution buzzer sounds one time.
UP
PTT switch
5. Press the "UP" side of the PTT switch for
three seconds and the buzzer will sound
twice briefly indicating the setting has been
canceled.
6. Return the throttle to the fully closed posi-
tion.
SETTING THE TILT UPPER POSITION
LIMIT
7. Press the "UP" side of the PTT switch so
that the optimum full tilt up position for the
boat can be obtained.
8. Turn the ignition key to the "ON" position.
9. Pull out the emergency stop switch lock
plate.
10. Make sure that remote control handle is in
"NEUTRAL".
11. Using the throttle only function of the
remote control box, move the warm-up lever
upward until the caution buzzer sounds one
time.
12. Press the "UP" side of PTT switch three
times within three seconds. The buzzer will
sound one time briefly indicating the setting
has been accepted.
13. Return the throttle to the fully closed posi-
tion and install the lock plate on the emer-
gency switch. Operate the full tilt up and full
down operations several times by pressing
the PTT switch and check that the setting of
both the trim lower limit and tilt upper limit
are properly set.
 WARNING
Setting of the tilt upper limit position will not
prevent the outboard motor from tilting fully
up and contacting the motor well if the
motor's lower unit hits an object at high
speed. Such tilting could damage your motor
and boat and injure the boat occupants.
Keep all occupants away from the motor when
operating at high speed.
MOTOR COVER FASTENING
ADJUSTMENT
If you feel motor cover fastening is loose or too
tight when locking the levers, adjust as follows:
1. Loosen the bolts 1, 2 and 3.
2. Adjust the position of brackets 4, 5 and 6.
To increase the fastening, move the brackets
to the direction A. To decrease the fasten-
ing, move the brackets to the direction B.
3. Tighten the bolts.
Motor cover
17