Diagnostic System; Oil Change Reminder System; System Activation - Suzuki DF100A Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 224

DIAGNOSTIC SYSTEM

If abnormal conditions exist in any sensor sig-
nal being input to the control unit, the self-diag-
nostic system warns of the abnormal condition.
If this system activates, the red CHECK
ENGINE lamp will flash and a buzzer will
sound.
Also incorporated is a fail-safe provision that
allows the operation at a restricted speed even
under such a failure condition.
The failed system can be identified by the mode
of the lamp flashing and buzzer sounding.
The diagnostic code is designed to appear
when the ignition key is turned on.
NOTICE
If the diagnostic system activates while you
are operating your outboard motor, there is an
abnormal condition in one of the sensor sig-
nals of the control system.
Consult your authorized Suzuki marine dealer
for repair of the control system.
NOTE:
The buzzer sound with diagnostic system acti-
vating will be canceled by pushing the ignition
key in.
OIL CHANGE REMINDER
SYSTEM
This system informs the operator of the time for
replacing engine oil on the basis of the mainte-
nance schedule.
The system is designed to register the total
operating hours of the outboard motor and
function its operation when the preprogrammed
hours have reached.
(Refer to the INSPECTION AND MAINTE-
NANCE section and the last page.)

SYSTEM ACTIVATION

When the total operating hours have reached
the preprogrammed hours, the OIL lamp will
flash. If the engine is not running, the buzzer
will begin a series of double beeps additionally.
This indication will repeat until you cancel the
system activation.
CANCELLATION
1. Turn the ignition key to the "ON" position.
2. Pull out the emergency stop switch plate 1.
3. Pull up the emergency stop switch knob 2
three times in 10 seconds. A short beep will
be heard if the cancellation is successfully
finished.
4. Turn the ignition key to the "OFF" position.
5. Set the plate 1 in the original position.
NOTE:
• Canceling of the system activation is possible
regardless of whether or not the engine oil
has been replaced. Once the system has
operated, however, Suzuki strongly recom-
mends that the engine oil be replaced before
canceling the system activation.
• Even if the engine oil has been replaced with
the system not operating, it is still necessary
to perform the cancellation.
21

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Df115aDf140a

Tabla de contenido