Fault Indication - Gram IF 4000 Manual De Uso

4-2 Troubleshooting

Fault Indication

Condition
Drive is indicating a fault.
The integral keypad provides visual notification of a
fault condition by displaying the following.
• Flashing fault number
• Flashing fault indicator
Press the Escape key to regain control of the
integral keypad.
Manually Clearing Faults
Step
1. Press Esc to acknowledge the fault. The fault information will be
removed so that you can use the integral keypad.
Access d007
2. Address the condition that caused the fault.
The cause must be corrected before the fault can be cleared.
See Table
3. After corrective action has been taken, clear the fault by one of these
methods.
• Press Stop if P037
• Cycle drive power.
• Set A100
• Cycle digital input if A051 - A052
"Clear Fault".
Automatically Clearing Faults
Option / Step
Clear a Type 1 fault and restart the drive.
1. Set A092
2. Set A093
Clear an OverVoltage, UnderVoltage or Heatsink OvrTmp fault
without restarting the drive.
1. Set A092
2. Set A093
Auto Restart (Reset/Run)
The Auto Restart feature provides the ability for the drive to
automatically perform a fault reset followed by a start attempt without
user or application intervention. This allows remote or "unattended"
operation. Only certain faults are allowed to be reset. Certain faults
(Type 2) that indicate possible drive component malfunction are not
resettable.
Caution should be used when enabling this feature, since the drive will
attempt to issue its own start command based on user selected
programming.
[Fault 1 Code] to view the most recent fault information.
4.A.
[Stop Mode]
[Fault Clear] to "1" or "2".
[Auto Rstrt Tries] to a value other than "0".
[Auto Rstrt Delay] to a value other than "0".
[Auto Rstrt Tries] to a value other than "0".
[Auto Rstrt Delay] to "0".
Display
is set to a value between "0" and "3".
[Digital Inx Sel] is set to option 7
RUN VOLTS
FWD AMPS
REV HERTZ
PRGOGRAM FAULT
Key(s)