Installation/Wiring
This chapter provides information on mounting and wiring the
PowerFlex 40 Drive.
For information on...
Opening the Cover
Mounting Considerations
AC Supply Source Considerations 1-3
General Grounding Requirements 1-4
Most start-up difficulties are the result of incorrect wiring. Every
precaution must be taken to assure that the wiring is done as instructed.
All items must be read and understood before the actual installation
begins.
ATTENTION: The following information is merely a guide for
proper installation. The Allen-Bradley Company cannot assume
!
responsibility for the compliance or the noncompliance to any code,
national, local or otherwise for the proper installation of this drive or
associated equipment. A hazard of personal injury and/or equipment
damage exists if codes are ignored during installation.
Opening the Cover
1. Press and hold in the tabs on each side of the cover.
2. Pull the cover out and up to release.
See page
For information on...
1-1
Fuses and Circuit Breakers 1-6
1-2
Power Wiring
I/O Wiring
Recommendations
EMC Instructions
1
Chapter
See page
1-8
1-12
1-22