Gram IF 4000 Manual De Uso página 348

Advanced Program Group
A092 [Auto Rstrt Tries]
Sets the maximum number of times the drive attempts to reset a fault and restart.
Clear a Type 1 fault and restart the drive.
1. Set A092 [Auto Rstrt Tries] to a value other than "0".
2. Set A093 [Auto Rstrt Delay] to a value other than "0".
Clear an OverVoltage, UnderVoltage or Heatsink OvrTmp fault without restarting the drive.
1. Set A092 [Auto Rstrt Tries] to a value other than "0".
2. Set A093 [Auto Rstrt Delay] to "0".
ATTENTION: Equipment damage and/or personal injury may result if this parameter
is used in an inappropriate application. Do not use this function without considering
!
applicable local, national and international codes, standards, regulations or industry
guidelines.
Values Default
Min/Max:
Display:
A093 [Auto Rstrt Delay]
Sets the time between restart attempts when
Values Default
Min/Max:
Display:
A094 [Start At PowerUp]
Stop drive before changing this parameter.
Enables/disables a feature that allows a Start or Run command to automatically cause the drive to
resume running at commanded speed after drive input power is restored. Requires a digital input
configured for Run or Start and a valid start contact.
This parameter will not function if parameter
ATTENTION: Equipment damage and/or personal injury may result if this parameter
is used in an inappropriate application. Do not use this function without considering
!
applicable local, national and international codes, standards, regulations or industry
guidelines.
Options 0 "Disabled" (Default)
1 "Enabled"
Programming and Parameters
(continued)
Related Parameter(s): A055, A058, A061,
0
0/9
1
A092 [Auto Rstrt Tries] is set to a value other than zero.
1.0 Secs
0.0/300.0 Secs
0.1 Secs
P036 [Start Source] is set to 4 "2-W High Speed".
Related Parameter(s):
3-27
A093
A092