Gram IF 4000 Manual De Uso página 326

Display Group
d012 [Control Source]
Displays the active source of the Start Command and Speed Command which are normally defined
by the settings of P036
inputs. Refer to the flowcharts on pages
Start Command
0 = Keypad
1 = 3-Wire
2 = 2-Wire
3 = 2-Wire Level Sensitive
4 = 2-Wire High Speed
5 = RS485 (DSI) Port
9 = Jog
Speed Command
0 = Drive Potentiometer
1 =
2 = 0-10V Input/Remote Potentiometer
3 = 4-20mA Input
4 =
5 = RS485 (DSI) Port
6 = Step Logic Control (Parameters
9 = Jog Freq
Reserved
Reserved
Values Default
Min/Max:
Display:
d013 [Contrl In Status]
Status of the control terminal block control inputs.
Important: Actual control commands may come from a source other than the control terminal block.
Start / Run FWD Input (I/O Terminal 02)
Direction / Run REV Input (I/O Terminal 03)
Stop Input
Dynamic Brake Transistor On
(1)
The stop input must be present in order to start the drive.
When this bit is a 1 the drive can be started.
When this bit is a 0 the drive will stop.
Values Default
Min/Max:
Display:
(continued)
[Start Source] and P038
1-20
A069 [Internal Freq]
A070-A077 [Preset Freq x]
(A051 - A053 [Digital Inx Sel] must be set to 4)
Read Only
0/9
1
1 = Input Present, 0 = Input Not Present
(1)
(I/O Terminal 01)
Read Only
0/1
1
Programming and Parameters
Related Parameter(s): P036, P038,
[Speed Reference] but may be overridden by digital
and 1-21 for details.
Digit 0
Digit 1
A140 - A147)
Digit 2
Digit 3
Related Parameter(s): d002, P034,
Bit 0
Bit 1
Bit 2
Bit 3
3-5
A051-A054
P035