Bar Routing With A Mechanical Groupset - Look 796 Monoblade RS Manual De Uso

External extension routing : If you are not sure of your position it is advisable to route the
shifter electric wires outside in the first case. This will allow you to recut your extensions
and add/remove shims without having the whole routing to redo.
To do this do not feed the wires into the extensions but run them along them. Feed the wires
into the bar notches, outside the spacers, before tightening the assembly. Hold the wires
onto the extensions with a turn of insulation tape.
Fig. 7

Bar routing with a mechanical groupset

Feed the derailleur cable outers into the frame before feeding them into the AEROFLAT BAR.
1- Follow points 4 to 8 of the previous paragraph.
2- Assemble the extensions onto the bar in the desired position. (Cf. § COCKPIT)
3- Thread the two derailleur cable outers coming out of the horizontal tube cap into each
extension. Bring them out through the oblong holes under the extensions and finalise the routing.
(Fig § mech. frame routing – use the fig. 7)
Volume (mm3)
GENERAL TOLERANCES :
Dimension from 0 to 15 : ±0.15
Dessiné par
Dimension from 15 to 30 : ±0.20
Beyond : ±0.25
Angles : ±30'
Surfaces finish : 80 grit sand blast
Vérifié par
Free of positive metal, voids and porosity
Free of cutting oil and oil residue
All information contained on this drawing is property of LOOK CYCLE INTERNATIONAL. Its reproduction for any use in any way or for commercial
purpose is forbidden. All rights on this material are reserved.
Nature de la modification
Matière
ECHELLE 1:3
Masse (g)
FORMAT A3
Date
Date
EN
Resp Date
Traitement
ENSEMBLE
DESIGNATION REFERENCE
14
Ind.