Complete Headset Assembly - Look 796 Monoblade RS Manual De Uso

5- Withdraw the top bearing②
5
support ring② .
6- Clean all the parts with a suitable cleaner and a soft cloth.
Note : you can remove the headset without taking the rear brake cable outer from the frame
and handlebars. Hold the handlebars on the side of the frame as far as possible during
headset maintenance operations.
1- Put the steering stop in place②
2- Apply a fine layer of grease on the fork where the split ring②
7
on the split ring
8
②(this could cause fouling of the housing and hinder rotation of the fork).
3- Apply a fine layer of grease to the bottom split ring②
6
② on it. Pay attention to the bearing direction.
4- Generously grease the headset top housing in the frame. Then stack: the housing bottom
5
ring② , the spring②, and the bearing support ring②
other correctly. Then slide on the bearing②
need any force. Deposit a fine layer of grease between each pair of parts.
5- Grease the headset bottom housing in the frame. Take care not to put grease into the
housing where the steering stop slides②
rotation of the fork).
6- Next slide in the fork, then refit the stem and pre-tighten the nut ②
torque whilst holding the stem by the bar fixing holes with a pin wrench. (Cf. § AEROFLAT
STEM)
2
, the support ring②

Complete headset assembly

8
②. Take care not to put grease into the housing and onto the steering stop
3
, the spring
in its housing (bean shaped) on the fork.
3
. Take care that the parts fit into each
2
, sliding it on absolutely straight, this should not
8
(this could cause fouling of the housing and hinder
4
and the housing bottom
7
is in contact with it. Thread
7
then position the bottom bearing
1 . Tighten it to 55 Nm
EN
22