Headset Adjustment - Look 796 Monoblade RS Manual De Uso

EN
You can modify the prestress applied to the headset bearings using the reversible ring②
obtain more or less fluid steering. The direction of this ring is shown by the marking «This side
up: Maximal load on steering headset».
Fig. 13
• If you want less firm or more firm steering when you turn the bike's handlebars, first check
that the headset assembly is correctly fitted, as described above. If it is correctly fitted you can
turn the reversible ring over by putting it with the marking downwards to reduce the headset
COUPE B-B
prestress.
• If your steering shows slight play with the ring markings downwards it can be removed by
orienting the ring with markings upwards so as to place the marking upward.
GENERAL TOLERANCES :
Dimension from 0 to 15 : ±0.15
Dimension from 15 to 30 : ±0.20
Beyond : ±0.25
Angles : ±30'
Surfaces finish : 80 grit sand blast
Free of positive metal, voids and porosity
Free of cutting oil and oil residue
All information contained on this drawing is property of LOOK CYCLE INTERNATIONAL. Its reproduction for any use in any way or for commercial purpose is forbidden. All rights on this material are reserved.
Important : If excessive play persists with the ring with marking upwards or if you steering is
too firm with the ring with marking downwards, you must approach your retailer to perform
a thorough evaluation.
23

Headset adjustment

B
L1 < L2
Nature de la modification
ECHELLE 3:1
Volume (mm3) Masse (g)
FORMAT A4
Dessiné par Date
Vérifié par Date
B
Matière
ENSEMBLE
DESIGNATION
3
to
Resp Date
Ind.
Traitement
REFERENCE PROTO
REFERENCE