Saddle Layback Modification - Look 796 Monoblade RS Manual De Uso

EN
cutting tool in a vice whilst orienting the slot in the vertical position.
7 - Cut the tube by inserting a saw into the saw slot. Use a special carbon saw, if not, a worn
metal saw blade.
8 - Remove the cutting tool, deburr the end of the tube with fine glasspaper. Check that the end
of the tube is clean and varnish free.
Fig. 38
Important : the recutting limit marked on the rear of the seat tube must be complied with for
correct operation of the assembly.
The AEROPOST is fitted with a short layback head facing forwards as original equipment. If you
need you can turn this part towards the rear or use the long layback version. To modify your
saddle layback :
1- Remove your saddle from the seatpost head (Cf. § Removing the saddle).
2- Withdraw the 2 fixing screws
3- Position the desired head in the direction wanted.
4- Put the 2 washers
5- Refit your saddle to the seatpost head.
45
A

Saddle layback modification

and the washers
7
and 2 screws
6
, then withdraw the head
6
, back in place, and tighten them to 4 Nm.
7
or
4 5