Trouble Shooting - SICE A 948 Manual De Instrucciones

Vehicles with hydro-pneumatic or intelligent suspension systems.
• Adjust the vehicle with the engine running and the suspensions for normal driving road
clearance.
• Even if the rear axle is fixed, measure the relative values to pick up on possible misalignment;
now adjust the front left and right half-toes with respect to the thrust axis in order to eliminate
the problem of a misaligned steering wheel.
Mains voltage incorrect or not present.
• Check the electrical plant and hook up the machine correctly.
Plug inserted in the wrong socket.
• Connect the plug properly.
One of the power fuse has blown.
• Renew the fuse.
Incorrect power supply voltage.
• Set the power supply voltage jumper to the correct position, check also the power supply of the
transformer.
Power switch at back of monitor is set to off.
• Set the monitor power switch to ON.
Keyboard connection cable is not inserted.
• Make sure the cable is inserted in the computer inside the aligner.
Faulty keyboard.
• Call the service centre.
Function key jammed (Alt, Alt Gr and Ctrl keys)
• Check all the keys and release as necessary.
•
The LED/s do not turn on.
• Burned LED/s or key that does not make the necessary contact.
• Keep pressing the defective key and if the defect is not eliminated, contact the technical
service department.
After pressing the ON-OFF key on a sensor, that sensor turns off after a few seconds.
Battery low.
• Charge the sensor or replace the battery.
Vehicles with fixed rear axle.

TROUBLE SHOOTING

The machine shows no signs of life
Keyboard
Keyboard not accepting commands.
Sensors
Sensor remains off.
54