SICE S 560 Manual De Instrucciones página 45

ENGLISH • Instructions manual
8) Press down on the lever and lower the wheel to bring the edge of the rim about
5 cm from the hooked tool.
9) Turn the wheel anticlockwise pressing down on lever LA until the bead is com-
pletely off.
10) Move the tool carrier arm to its non-working position and then move it to the
inside plane of the wheel.
11) Take the mobile control unit to work position D.
12) Turn the hook tool 180° and insert it between rim and bead (see Fig. L).
Move it until the bead is by the edge of the rim (best to do this with the wheel
turning).
13) Move the rim about 4-5 cm from the tool making sure the hook does not detach
from the rim.
14) Take the mobile control unit to work position B.
15) Move the hook tool so that its red reference dot is about 3 cm inside the rim.
16) Insert lever LA (17, Fig. I) between rim and bead at the right of the tool.
17) Press down on the lever and lower the wheel to bring the edge of the rim about 5 mm from the hooked tool.
Turn the wheel anticlockwise pressing down on lever LA until the tyre comes completely off the rim.
DANGER!
When the beads come off the rim, the tyre will fall.
Check to make sure there are no by-standers in the work area.
MOUNTING
Tubeless tyres can be mounted using either the bead breaker disk or the hook tool.
If the tyre is not problematic, use the bead loosener disk.
If the tyre is very rigid, the hook tool must be used.
TYRE MOUNTING WITH THE DISK
Follow these steps:
1) If the rim has been removed from the spindle, put it back on the spindle as described
in the section on "CLAMPING THE WHEEL".
2) Lubricate both beads and the rim with tyre manufacturer recommended lubricant.
3) Attach the PC clip to the outside edge of the rim at the highest point.
CAUTION: Use clip PL with the special plastic guards for alloy rims (See Fig. M).
CAUTION!
Make sure the clip is firmly attached to the rim.
4) Take the mobile control unit to work position B.
45
L
M
S 560