SICE S 560 Manual De Instrucciones página 56

4) Take the mobile control unit to work position B.
5) Move the tyre on the platform.
6) Lower or raise the spindle to centre the rim and the tyre (see Fig. Z/8).
7) Translate the turntable outward so the rim can be inserted in the tyre.
Move forward until it is completely inserted.
8) Fit the ring with taper housing on the rim (with the outer side ring assembled).
NB: If the ring with taper housing has grooves for fasteners, these must be "in
phase" with each other.
9) Take the mobile control unit to work position C.
10) Move the tool carrier arm to the outside in its work position with the bead
breaker disk turned towards the wheel.
NB: If the ring with taper housing has not fitted into the rim to a sufficient extent,
move the spindle until the bead wire is on a level with the bear loosener disk.
Bring the disk forward (with the spindle turning) until you "uncover" the O-ring
seating (see Fig. Z/9).
11) Lubricate the O-ring and insert it into its housing.
12) Take the mobile control unit to work position B.
13) Position the locking ring on the rim with the help of the disk as shown in Fig. Y/2.
14) Move the tool carrier arm to its non-working position.
15) Lower the turntable until the wheel touches the platform.
16) Close the arms of the spindle completely.
Support the wheel to prevent it falling off.
DANGER!
This operation can be extremely dangerous.
Do it manually only if you are certain you can keep the
wheel balanced.
For large and heavy tyres an adequate lifting device must
be used.
17) Translate the turntable moving the wheel away from it.
18) Remove the wheel.
DANGER!!
Do not inflate the tyre with the wheel mounted on the
spindle.
Tyre inflation is dangerous and should only be done by
removing the wheel from the spindle and placing it
inside a safety cage.
S 560
56
ENGLISH • Instructions manual
Z/8
Z/9
Y/2