SICE S 560 Manual De Instrucciones página 49

ENGLISH • Instructions manual
18) Press down on the lever and lower the wheel to bring the edge of the rim about
5 cm from the hooked tool.
Turn the wheel anticlockwise pressing down on lever LA until the tyre comes com-
pletely off the rim.
DANGER!
When the beads come off the rim, the wheel will fall.
Check to make sure there are no by-standers in the work
area.
MOUNTING
1) If the rim has been removed from the spindle, put it back on the spindle as
described in the section on "CLAMPING THE WHEEL".
2) Lubricate both beads and the rim with tyre manufacturer recommended lubricant.
3) Attach the PC clip to the outside edge of the rim at the highest point.
CAUTION!
Make sure the clip is firmly attached to the rim.
4) Take the mobile control unit to work position B.
5) Position the tyre on the platform.
6) Turn the spindle until the clip reaches the 6 o'clock position (See Fig. Q/2).
7) Lower the spindle so that the clip can "enter" into the tyre, then move forward
until the rim touches the actual tyre itself (see Fig. Q/3).
8) Turn the spindle clockwise while moving forwards, so that the clip takes up the
tyre bead.
Turn until the clip reaches the 11 o'clock position.
9) Lift the rim with the tyre connected.
The tyre will position obliquely to the rim (see Fig. Q/4).
10) Move the tool carrier arm to its non-working position.
Move it to the inside plane of the tyre and rehook it in this position.
11) Check to make sure the hook tool is positioned on the wheel side.
If not, turn it 180°.
12) Take the mobile control unit to work position D.
13) Move the tool forward until the red reference dot is lined up with the outside
edge of the rim and about 5 mm from it (See Fig. S).
14) Take the mobile control unit to work position C.
15) Move to the outside of the wheel and check the exact position of the hook
visually and adjust it as needed.
Then turn the spindle clockwise until the clip is at the bottom (6 o'clock).
49
Q/3
Q/4
S
S 560