Removing The Rear Wheel - SWM SM 500 R E4 2018 Manual - Uso - Mantenimiento

REMOVING THE REAR WHEEL

Unscrew the nut (1) of the wheel axle (3) and extract
it. It is not necessary to loosen the chain tension-
ers (2); in this way, the chain tension will remain
unchanged after reassembly. Extract the complete
rear wheel, keeping the spacers located at the hub
sides.
To reassemble, reverse the above procedure re-
membering to insert the brake disc into the calliper.
(Coupling torque of the nut (1) 142 Nm / 14,48 Kgm
/ 104, 73 ft/lb.)
1
EN - 50
Note*: Do not operate the rear brake pedal when
the wheel has been removed; this causes the cal-
liper pistons to move outwards.
After removal, lay down the wheel with brake disc
on top.
After reassembly, depress the brake pedal until the
pads are against the brake disc.
3
2
TYRES
Care should be taken to keep the tyres properly in-
flated. See "Technical data" chart at the beginning
of the manual for correct tyre inflation pressure.
Replace the tyre if its wear exceeds reference val-
ues on the table below.
MINIMUM HEIGHT
OF THE TREAD
FRONT 0.08 in.
REAR 0.08 in.