Appendix - SWM SM 500 R E4 2018 Manual - Uso - Mantenimiento

Ocultar thumbs Ver también para SM 500 R E4 2018:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

APPENDIX

LONG PERIOD OF INACTIVITY
When the motorcycle is to be stored for a certain
period, it should be prepared for storage as follows:
- clean the entire motorcycle thoroughly.
- Drain all fuel from the tank.
- Fill the tank with fuel added with a stabiliser
WARNING*: Never release fuel into the environ-
ment or let the engine run indoors.
- Lubricate the final drive chain and all the cables.
- Spray oil on all unpainted metal surfaces to pre-
vent rusting. Avoid getting oil on rubber parts or
brakes.
- Set the motorcycle on a support or stand so that
both wheels are raised off the ground (if this can-
not be done, put boards under the wheels to keep
moisture away from the tyres).
- Tie a plastic bag over the exhaust pipe to prevent
moisture from entering.
- Put a cover over the motorcycle to keep dust and
dirt from collecting on it.
To set the motorcycle back ready for use after stor-
age:
- Make sure the spark plug is tight.
- Fill the fuel tank.
- Run the engine to warm the oil up then drain the
oil.
- Refill with fresh oil.
- Check all the points listed under the inspection
and Adjustment Section (Appendix A).
- Lubricate all the points listed under the "Lubrica-
tion" Section (Appendix A).
1
2
CLEANING
Before washing the motorcycle, it is necessary to
duly protect the following parts:
a) Rear opening of the muffler;
b) Air filter intake;
c) Clutch and brake levers, hand grips, handlebar
commutators;
d) Fork head, wheel bearings;
e) Rear suspension links.
DO NOT INSIST WITH HIGH PRESSURE JETS OF
WATER OR AIR on the ELECTRIC PARTS and on
the INJECTION SUPPLY SYSTEM, especially the
electronic control unit (1) and the throttle body
sensors unit (2).
After washing:
- Lubricate the points listed in the "Maintenance
Chart" (Appendix A).
- Briefly warm up the engine
- Test the brakes before riding the motorcycle.
WARNING*: Never wax or lubricate the brake
discs. Loss of braking efficiency and an acci-
dent could result. Clean the disc with a solvent
such as acetone.
EN - 71

Publicidad

Tabla de contenido
loading

Tabla de contenido