Instructions And Safety Information; General Safety Information - salmson Rocsan EVO Serie Instalacion Y Puesta En Servicio

English
authorized add-ons and modifications or the use of non-original
spare parts can seriously damage the product and injure person-
nel.
1.8.4. Maintenance
The prescribed maintenance and inspection work should be car-
ried out regularly. This work may only be carried out by qualified,
trained and authorized personnel. Maintenance not listed in this
operation and maintenance manual, and any type of repair work,
may only be performed by the manufacturer and authorized ser-
vice centers.
1.8.5. Damage to the product
Damage and malfunctions that endanger safety must be elimi-
nated immediately by trained personnel. The product may only be
operated if it is in proper working order. During the agreed warran-
ty period, the product may only be repaired by the manufacturer
or an authorized service center. The manufacturer reserves the
right to ask the operator to return the damaged product to the
factory for inspection.
1.8.6. Exclusion from liability
No liability will be assumed for product damage if any of the fol-
lowing items apply:
• The manufacturer deems that information provided by the
operator or customer is insufficient or incorrect
• Failure to observe the safety instructions, the regulations
and requirements of German law or the applicable local
laws, or of this operating and maintenance manual
• Improper use
• Incorrect storage and transport
• Improper assembly or dismantling
• Insufficient maintenance
• Unqualified repairs
• Inadequate construction site or construction work
• Chemical, electrochemical and electrical influences
• Wear
This means the manufacturer's liability excludes all liability for
personal, material or financial injury.
2. Safety
This section lists all the generally applicable safety instructions
and technical information. Furthermore, all the other sections
contain specific safety instructions and technical information.
All instructions and information must be observed and followed
during every phase of the product's life cycle (installation, opera-
tion, maintenance, transport etc.). The operator is responsible for
ensuring that personnel follow these instructions and guidelines.
2.1.

Instructions and safety information

This manual uses instructions and safety information to prevent
injury and damage to property. To clearly identify them for per-
sonnel, the instructions and safety information are distinguished
as follows:
2.1.1. Instructions
Instructions are displayed in bold type. Instructions contain text
that refers to the previous text or particular sections, or highlights
short instructions.
Example:
note that products stored with drinking water must
be protected from frost.
2.1.2. Safety information
Safety information is slightly indented and displayed in bold type.
It always commences with a signal word.
Information that only refers to material damage is printed in gray,
without safety symbols.
Information that refers to personal injury is printed in black and
is always accompanied by a safety symbol. Danger, prohibition or
instruction symbols are used as safety symbols.
Example:
Danger symbol: General hazard
Danger symbol, for example, electrical current
Prohibition symbol, for example, Keep out!
Instruction symbol, for example, wear
protective clothing
The safety symbols used conform to the generally applicable
directives and regulations, such as DIN and ANSI.
Each safety instruction begins with one of the following signal
words:
• Danger
This can result in serious or fatal injuries!
• Warning
Serious injuries can occur!
• Caution
Injuries can occur!
• Caution (instruction without symbol)
Substantial material damage can occur. Irreparable dam-
age is possible!
Safety instructions begin with a signal word and description of the
hazard, followed by its cause and potential consequences, and end
with advice on prevention.
Example:
Beware of rotating parts!
The moving impeller can crush and sever limbs.
Switch off the device and let the impeller come to a
halt.
2.2.

General safety information

• When installing or removing the product, never work alone
in rooms and shafts. A second person must always be
present.
• The product must always be switched off before any work
is performed on it (assembly, dismantling, maintenance,
installation). The product must be disconnected from the
37