Audio - Blackmagic Design HyperDeck Extreme 8K HDR Manual De Instalación Y Funcionamiento

Audio

Audio Page 1
The audio input displays audio meters for embedded, XLR and RCA audio inputs. You can
select to display PPM or VU Meters. To change your meter type, see the 'setup' settings later in
this manual.
Video
XLR
RCA
Audio Page 2
Swipe the audio tab left or right to reveal the XLR output audio meters screen to navigate to the
XLR output controls. You can adjust the levels for all four XLR outputs. Adjust the level by
dragging the slider beneath each channel to the left to reduce the output volume, or to the right
to increase the volume. The type of audio meter displayed depends on the meter selected in
the setup tab. XLR audio outputs can be used to connect audio to other devices such as the
ATEM Constellation 8K switcher.
Adjust the XLR Output channels using the slider beneath
Click on the video tab for audio embedded in SDI and HDMI signals.
If you have selected 2 channels of audio on the record tab, only the top
two channels will be active.
When recording audio from an XLR input, you can change the input
level using the slider beneath each channel.
If you are using audio connected via RCA, only channels 1 and 2
are active.
Settings 32