Starting Record - Blackmagic Design HyperDeck Extreme 8K HDR Manual De Instalación Y Funcionamiento

TIP For more information on codecs and available quality settings, see the 'codec and
quality' section in the record menu later in this manual.

Starting Record

Now that you have set your source and codec, you can start recording.
Press the 'record' button on the front panel, or tap the red record icon on the touchscreen.
You can see your HyperDeck is recording because the record button will illuminate red along
with the timecode display and media icon. To stop recording, simply press either the
touchscreen or front panel 'stop' button. If you press 'play' while your HyperDeck Extreme is
recording, the recording will cease and playback will begin immediately from the first frame of
the recording. This means you can stop recording and start playback with the press of a
single button!
Media Warning Indicator
If you are recording Ultra HD or high quality 8K video using slower media, you may experience
problems with your media. For example, 8K recording uses a higher data rate compared to Ultra
HD, so your CFast cards need to be the fastest available. If there are problems with your media
during recording, you will see a red exclamation icon above the audio meters on the
touchscreen overlay.
An exclamation mark will appear in the lower right hand corner of the
display if problems with your media have been detected
We strongly recommend making sure your media is on the approved media list, which can be
found in the 'storage media' section later in this manual.
Recording 9