Blackmagic Design HyperDeck Extreme 8K HDR Manual De Instalación Y Funcionamiento página 61

Ocultar thumbs Ver también para HyperDeck Extreme 8K HDR:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 355
To locate your timecode point, make sure your 'player' has reference and is in remote, then on
the controller:
1
Press the 'recorder' button to control the deck you have previously selected as your
record deck.
2
Press the REW to F FWD buttons to rewind or fast forward.
3
Once you have reached your timecode, press STOP to stop playback and define select
your in point by pressing the 'entry' and 'in' buttons together.
1
1
2
3
4
The HyperDeck Extreme Control also features other transport controls for file based decks.
1
2
2
3
4
Skip forward and skip back
If you are using a file based deck for record or playback, such as the HyperDeck Extreme 8K
IN
OUT
ENTRY
HDR, you can use the 'skip' forward and reverse buttons. Press 'skip' reverse once to skip back
to the first frame of the current clip. Press 'skip' forward and you will skip forward to the first
frame of the next clip.
DELETE
INPUT
PREROLL
SKIP
EDIT
EJECT
REW
The 'skip' buttons are either side of the 'rec' button. Pressing
'skip' reverse when already located on the first frame of a
clip will navigate you to the first frame of the previous clip.
Record
To start recording, press the 'rec' and 'play' buttons at the same time. During recordings you
can switch which storage media your HyperDeck Extreme 8K HDR is recording to by holding
down the record button for three seconds.
Input
Press the INPUT button to switch between playback or source mode on the recording deck.
When input is selected, the HyperDeck Extreme 8K HDR will display the connected source.
Preroll
When you press 'preroll', tape decks will rewind to the preroll point before the set in point. The
preroll duration can be set on broadcast decks and is often set to up to 5 seconds. For
example, if the preroll on a broadcast deck is set to 5 seconds and the preroll button is pressed
on the deck or HyperDeck Extreme Control, the deck will search and park the tape 5 seconds
prior to that point. This is important for tape based decks where the deck needs time to lock the
signal before it is useable.
Edit
Once you have set your in and/or out points on your playback and record units, pressing 'edit'
will perform an auto edit, cueing your tapes to the preroll point and then starting the record.
The 'edit' button will flash when recording has started.
Eject
The 'eject' button has two different functions depending on whether you are connected to a
traditional tape based broadcast deck or a file based deck such as the HyperDeck
Extreme 8K HDR.
PLAYBACK
5
6
7
5
6
7
RECORD
TRIM
PLAYER
REC
SKIP
PLAY
F FWD
HOURS
8
M
SHUTTLE
8
M
RECORDER
REF
SERVO
REMOTE
STOP
HyperDeck Extreme Control Workflow
MINUTES
SECONDS
FRAMES
JOG
POSITION
61

Publicidad

Tabla de contenido
loading

Productos relacionados para Blackmagic Design HyperDeck Extreme 8K HDR

Este manual también es adecuado para:

Hyperdeck extreme control

Tabla de contenido