Rs-422 Control; What Is Rs-422 Control; Using An External Rs-422 Controller - Blackmagic Design HyperDeck Extreme 8K HDR Manual De Instalación Y Funcionamiento

On the rear cable brackets, insert a cable tab insert into the top and bottom holes on
one unit, securing each in place using the supplied support bracket screws. Attach the
two t-shaped supports between the two units at the front and rear and screw in place
using support brackets screws.
3 The cable tab insert installed previously should line up with the holes of the cable
bracket on the other unit. Secure with the supplied support bracket screws. You can
now turn the unit right side up.
4 Attach the rack ears to the outer edges near the front of both units using the supplied
rack ear screws. Your HyperDeck Extreme 8K HDR and HyperDeck Extreme Control
are now ready to be mounted into your rack as a single unit.

RS-422 Control

What is RS-422 Control?

The RS-422 standard is a serial deck control broadcast standard and has been used by
broadcasters since the early 1980s and is found on many decks, linear editors, non linear
editors and broadcast automation products. All current HyperDeck models support this
standard so can be integrated into broadcast automation, remote control systems, editing
systems and any kind of custom control you might like to design yourself.
HyperDeck Extreme 8K HDR also supports file based commands from the Advanced Media
Protocol via RS-422. This lets you control your HyperDeck with an external device using AMP
commands such as adding clips to a playlist, determining the filename of the next clip, looping a
single clip or timeline, or clearing a playlist.

Using an External RS-422 Controller

All current HyperDeck models feature an industry standard Sony™ compatible RS-422 deck
control port, which has the correct pin connections for a direct connection to any remote
controller that supports RS-422.
You can use pre-manufactured 9 pin cables as long as each end of the cable is wired 'pin for
pin' where the same pin numbers on each end of the cable are connected together. If you
would like to make custom cables, please refer to the accompanying wiring diagram.
Using RS-422 control means you can build your own custom controller, or incorporate your
HyperDeck Extreme 8K HDR into an already existing RS-422 control solution.
For example, you can remotely start and stop recording and playback of your HyperDeck as
well as performing other common jog and shuttle functions. The full list of supported RS-422
RS-422 Control 66