Use Conditions; Preparations By Client - resto italia KUBE 1 Manual De Instruccion

Eventual ingredients used for the preparation must not be risky for the operator's health, besides they must not de-
termine potentially explosive zones. Always consult the technical and safety cards relative to the dangers of each food
product. In case of dusty areas, e.g. dusting of flour, wear protection mask.
The series includes the following models:
• KUBE 1
• KUBE 2
• KUBE 2 Plus
2.5. CONDICIONES DE USO
Data for all the models (Table 2.5.1.):
Nature of current and frequency
Current value
Nominal use voltage
Conditioned expected nominal short circuit
current
Ground and neutral
Protection degree
Machine position
Use place
Maximum operating temperature
Relative humidity
Min. working environment illumination
Further use conditions
Protection device recommended against the overcurrents (Table 2.5.2.):

2.6. PREPARATIONS BY CLIENT

The purchaser must prepare a support surface for the machine as indicated in the Table 2.5.1.
•The power supply installation must comply with the indications of the national rules in force of the place and equipped with effi-
cient earthing;
•Positioning an omnipolar cut-off device on the feeding line, upstream of the machine;
•The feeding electric cables must be sized according to the max. current requested by the machine in such a way that the total full
load voltage fall is lower than 2%.
If the electric cable is damaged, it must be replaced by the manufacturer, by the service assistance or by a qualified technician in
order to avoid possible dangers.
ELECTRIC OVEN
See machine plate (see Fig. 2.2.)
See machine plate (see Fig. 2.2.)
See machine plate (see Fig. 2.2.)
6 kA symmetrical
TT and TN
IPX1
Work bench used in the food sector, height between 900 / 1000
mm from walk-over flooring, where you can circulate freely around the machine with
a free space at least of 800 mm
Inside
+ 40° C
10 ÷ 80 %
500 lx
• machine not suitable to work in environments with contaminants, e.g. dust, cor-
rosive gases etc.
• machine not suitable to work in environments with potentially explosive atmo-
spheres
• machine not suitable to work in environments with ionizing radiation, e.g. mi-
crowaves, ultraviolet rays, lasers etc.
• electric equipment not suitable to work in environments with vibrations and im-
pacts: in case, mount anti-vibration supports
Nominal insulation voltage
Nominal current
Thermal relay adjustment
Max. value of the fault loop impedance
KUBE 1
2
KUBE2
KUBE 2 PLUS
Ui ≥ 690 V
See Table 2.7.
See Table 2.7.
0.1 Ω
30
0.0