Troubleshooting - Fulgor Milano FCLVSD 150 TC Manual De Uso E Instalación

Most of the problems that occur during daily use of the packaging machine can be eliminated personally. The following table
serves as a support.
Request the intervention of Technical Assistance if it is not possible to solve the problem personally.
Problem
The packaging machine does not
come out of the drawer.
The packaging machine does not
switch on
The packaging machine is off.
The keys do not react to the commands. • The surface of the control panel is
The lid doesn't open.
Too much air remains in the sealed
bag.
The sealing bar is raised but sealing is
not performed.
Cause
• Guides "push to open" system
jammed.
• Coiled power cable jammed.
• The packaging machine is not
powered.
• The power plug is not inserted in the
socket.
• No electrical power.
• Electronic fault.
dirty or wet.
• A cycle is running.
• There is no indicator light illuminated
on the panel
• The bag is not suitable to the
dimensions of the product to be
packaged.
• The level of vacuum chosen is too
low.
• The product is liquid.
• The protection device of the sealing
bar is activated.
• The sealing bar is broken.

13 - Troubleshooting

Solution
• Contact the installer.
• Contact the installer.
• Check that there is power to the
socket used.
• Insert the plug of the power supply
into the socket.
• Disconnect the electrical
supply.
• Contact the technical support
service.
• Clean and dry the surface of the
control panel.
• It is normal that during the operating
cycles the lid remains closed. Wait
for the end of the cycle or press
to interrupt the cycle and
STOP
emptythe tray.
• During the cycle there is no electrical
power. NEVER ATTEMPT TO OPEN
THE LID. Restore the power supply
and wait for decompression of the
tray.
• Use a bag of suitable size.
• Repeat the cycle with a higher level
of vacuum.
• It is normal that with a liquid product,
some air bubbles remain inside.
• In the bottom right of the packaging
machine there are 2 buttons (A) that
restore the internal protections. Press
the keys to restore the protections. If
the fault recurs contact the Technical
Support service.
• Contact the Technical
service.
EN
power
Support
19