Fulgor Milano FCLVSD 150 TC Manual De Uso E Instalación página 53

Problem
At the end of a CHEF cycle, the symbol
remains on.
At the end of a MAx bag cycle, the
machine does not seal the bag and the
symbol flashes.
At the end of a MED bag cycle, the
symbol flashes.
At the end of a MAx container cycle,
the symbol flashes.
During a cycle comes
accompanied by an audible signal.
During a cycle with external container
comes on accompanied by an
acoustic signal.
The cycle completes, the symbol
flashes along with an acoustic
warning.
It comes on and flashes
Cause
• The product inserted is too hot or
with a quantity of liquid above the
indicated amount.
• The vacuum is not activated. The lid
on,
has not been closed.
• The vacuum is not activated. There is
dirt on the seal of the lid.
• The vacuum is not activated. The lid
seal is broken.
• The pump won't start. The pump
protection has been activated.
• The lid of the external container is
not positioned correctly.
• The external suction device was not
properly connected.
• Vacuum sensor fault
• Many consecutive
.
performed and the oil in the pump
has overheated.
Solution
• Cool the product to 3°C and/or
reduce the liquid part.
• When the cycle has been started,
gently press the lid to activate the
vacuum.
• Clean the tray and the seal.
• Contact
service for replacement.
• In the bottom right of the packaging
machine, there are 2 buttons (A) that
restore the internal protections. Press
the keys to restore the protections. If
the fault recurs contact the Technical
Support service.
• Correctly position the lid of the
external container.
• Correctly
suction device to the packaging
machine and to the container.
• Contact
service.
cycles were • Cool the packaging machine for at
least 1 hour.
the Technical Support
connect the external
the Technical Support
EN
21