Fulgor Milano FCLVSD 150 TC Manual De Uso E Instalación página 52

EN
Problem
Sealing is not optimal
Problem
Flashes
20
Cause
• The level of sealing set is not correct
for the type of bag being used.
• Many consecutive cycles
performed with sealing.
• The bag is larger than the sealing
bar.
• The edge of the bag
positioned correctly.
• The edge of the bag is dirty.
• The counter-pressure rubber and the
sealing bar are dirty.
• The counter-pressure rubber and the
sealing bar are damaged.
Cause
• The pump has absorbed humidity
and impurities.
Solution
• Repeat the cycle by adjusting the
sealing level.
were • Wait at least 2 minutes between
one cycle and another to allow the
sealing bar to cool.
• Use a suitable bag.
was not • Position the edge of the bag
centrally and so that it protrudes
approximately 2 cm from the sealing
bar.
• Avoid the edge forming creases
close to the sealing bar.
• When the product is inserted, turn
the edge of the bag over so that the
outer part remains clean.
• Clean the sealing bar and the
counter-pressure rubber.
• Contact the
service.
Solution
• Start the DRYING CYCLE.
• Take more care to cool products to
3°C and/or respect the liquid part
quantities inserted into the bag or
container.
Technical Support