Publicidad
Idiomas disponibles
Idiomas disponibles
GB
F
D
E
I
P
PROBLEM
Engine will not start.
[Make sure ignition switch
is in the RUN(I) position].
Engine starts but will not
accelerate properly.
Engine starts, then dies.
Engine starts but will not run
properly at high speed.
Engine does not reach full speed
and/or emits excessive smoke.
Engine starts, runs, and
accelerates but will not idle.
Chain turns at idle.
HCS3435A-25lgs manual.indd Sec1:45
HCS3435A-25lgs manual.indd Sec1:45
NL
S
DK
N
FIN GR HU
English
TROUBLESHOOTING
POSSIBLE CAUSE
No spark.
Engine is flooded.
Carburettor requires "L"
(Low jet) adjustment.
Carburettor requires "L" (Low Jet) Contact an authorised service centre for
adjustment.
Carburettor requires "H"
(High jet) adjustment.
Lubricant/fuel mixture incorrect.
Air filter dirty.
Spark arrester screen dirty.
Carburettor requires "H"
(High jet) adjustment.
Carburettor requires adjustment
to idle speed.
Carburettor requires adjustment
to idle speed.
Air leak in the intake system.
45
CZ RU
RO PL SLO HR TR EST LT
SOLUTION
Clean or replace spark plug. Reset spark
plug gap. Refer to Spark Plug Replacement
earlier in this manual.
With the ignition switch OFF, remove spark
plug. Move choke lever to run position
(pushed in completely) and pull starter cord
15 to 20 times. This will clear excess fuel from
engine. Clean and reinstall spark plug. Set
ignition switch to run ( l ) position. Push and
fully release primer bulb 7 times. Pull starter
three times with choke lever at run. If engine
does not start, move choke lever to FULL
choke and repeat normal starting procedure.
If engine still fails to start, repeat procedure
with a new spark plug.
Contact an authorised service centre for
carburettor adjustment.
carburettor adjustment.
Contact an authorised service centre for
carburettor adjustment.
Use fresh fuel and the correct 2-cycle
lubricant mix ratio.
Clean air filter. Refer to Cleaning the Air
Filter in the Maintenance section of this
manual.
Clean spark arrestor screen. Refer to
Inspecting/Cleaning the Spark Arrestor
Screen in the Maintenance section of
this manual.
Contact an authorized service centre for
carburettor adjustment.
Turn idle speed screw "T" clockwise to
increase idle speed. Refer to Adjusting the
Carburettor in the Maintenance section of
this manual.
Turn idle speed screw "T" counter clockwise
to decrease speed. Refer to Adjusting the
Carburettor in the Maintenance section of
his manual.
Contact an authorised service centre for a
rebuild kit.
LV
SK BG
12/19/08 6:10:41 PM
12/19/08 6:10:41 PM
Publicidad
