Descargar Imprimir esta página

Incorrect Operation - Columbus McKinnon Yale HTP Serie Instrucciones De Servicio

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 56
24
The air gap between the wheel flange and the beam flange ("dimension A") must range
between 1.0 and 2.5 mm on either side of the trolley (depends on model) in order to avoid a
potential source of ignition.
Trolleys must only be used with fitted buffers in order to exclude any spark formation.
Once the trolley width has been adjusted, the clevis of the load bar must be in the illustrated
position relevant to the beam. The top hook of the hoist must only be hung into the clevis in
this condition. The weight of the hoist automatically secures the adjustment of the trolley.
The operator must ensure that the hoist is suspended in a manner that makes it possible to
operate the unit without exposing himself or other personnel to danger by the unit itself, the
suspension or the load.
The operator may start moving the load only after it has been attached correctly and all
persons are clear of the danger zone.
Do not allow personnel to stay or pass under a suspended load.
A lifted or clamped load must not be left unattended or remain lifted or clamped for a longer
period of time.
Loads suspended from a trolley without a gear drive must be pushed. The load must not be
pulled.
If the area in front of the load is not sufficiently visible, the operator must ensure he is given
help.
The hoist may be used at ambient temperatures between –20° and +40°C. Consult the
manufacturer in the case of extreme working conditions.
Prior to operation of the hoist in special atmospheres (high humidity, salty, caustic, alkaline) or
handling hazardous goods (e.g. molten compounds, radioactive materials), consult the
manufacturer for advice.
Always transport the load in the horizontal direction slowly, carefully and close to the ground.
Only use safety hooks with safety latches.
For attaching a load, only approved and certified lifting tackle must be used.
Correct operation involves compliance with the operating instructions and in addition also
compliance with the maintenance instructions.
In case of functional defects or abnormal operating noise, stop using the hoist immediately.
Maintenance work and the annual inspection of the units must not be carried out in rooms with
an explosion hazard.
I
O
NCORRECT
PERATION
(List not complete)
Do not exceed the rated load capacity (WLL) of the unit and/or the suspension and the
supporting structure.
Removing or covering labels (e.g. by adhesive labels), warning information signs or the
identity plate is prohibited.
©
2016 Columbus McKinnon Industrial Products GmbH

Publicidad

loading