Assembly - Columbus McKinnon Yale HTP Serie Instrucciones De Servicio

26
A unit changed without consulting the manufacturer must not be used.
Do not use the hoist for the transportation of people.
Incorrect attachment to or incorrect loading of the clevis load bar, i. e. applying load to the
"flat" side of the suspension eye, is forbidden.
Enlarging the adjusted trolley width, e. g. to enable the trolley to negotiate smaller curve radii,
is forbidden.
Only units fitted with hooks with safety latches must be suspended in the clevis of the load bar.
Make sure that the hook is not too large. The clevis must be seated centrally in the saddle of
the hook and the hook must be freely articulating in the clevis at the same time.
Only one load lifting attachment or hoist may be suspended in the clevis of the trolley load bar.
ATTENTION: The suspended hoist or load lifting attachment must also be suitable for
the ATEX area.
Never reach into moving parts.
Do not allow the unit to fall from a large height. Always place it properly on the ground.
The unit may be used in potentially explosive atmospheres (note identification!).
A
SSEMBLY
ATTENTION: The unit must only be assembled in atmospheres without an explosion
hazard, since it cannot be excluded that during assembly spark formation caused by
handling of tools may occur. Non-sparking explosion-protected tools must be used.
It is urgently recommended that a verification measurement be carried out!
Inspection of the supporting structure
The supporting structure has to be selected to ensure that it has sufficient stability and the
expected forces can be safely absorbed.
Make sure that no impermissible additional loading may occur as a result of fitting the hoist
(e.g. by side pull).
The selection and calculation of the appropriate supporting structure are the responsibility of
the operating company.
©
2016 Columbus McKinnon Industrial Products GmbH