TOHATSU EverRun MX50D2 Manual De Servicio página 116

Maintenance
1
2
1
Do not reuse.
5
3
6
3-12
All manuals and user guides at all-guides.com
Flushing using drive cleaner (Commercially Available Item)
Put drive cleaner 1 on the gear case from the front so
1.
that the drive cleaner covers cooling water inlet as shown.
2. Put water hose to drive cleaner and run water.
3. Set shift lever to neutral (N) and start engine.
4. Check that cooling water check port discharges water, and
run engine for 3 to 5 minutes at idle speed.
Inspection of Water Pump
1. Remove the following part.
Drive out spring pin 1 by using spring pin tool 2.
1
6
● Remove gear case ass'y from drive shaft housing.
2. Remove the following parts.
3 Gear Case Plate
4 Bolts : M8 4 pcs. (MX50D2 : M8 6 pcs.)
5 Bolts : M10 2 pcs.
6 Gear Case Ass'y (Pull downward to remove.)
4
Adjust water flow so that water leaks from driver
cleaner a little.
Spring Pin Tool A 2:
P/N. 345-72227-0 (ø3.0)
GB
2st X50D2 2011