Inspection Of Propeller Shaft Ass'y - TOHATSU EverRun MX50D2 Manual De Servicio

Lower Unit
7
a
a Supporting Points
c
b
6-48
All manuals and user guides at all-guides.com
3. Pull out clutch pin 4, and remove clutch spring retainer
5, clutch spring 6, and clutch by referring to the figure.
4
1
After taking out clutch spring retainer 5 and clutch spring
4.
6, remove clutch 7 from propeller shaft.

17) Inspection of Propeller Shaft Ass'y

1. Check propeller shaft for bend, wear and damage.
Replace if necessary.
2. Measure propeller shaft runout.
a
Check clutch claw b and push rod c for crack and wear.
3.
Replace if necessary.
WARNING
· When removing clutch
protective glasses, and do not point
opening of propeller shaft to your face or
body while holding the propeller shaft.
Clutch pin or spring holder may fly out
very quickly.
· Install push rod 1, and pull out pin 4
while pushing propeller shaft onto a plane
to prevent retainer 5 and spring 6 from
flying out.
Runout Limit :
0.05 mm (0.0020 in)
GB
pin, wear
2st 50D2 2011