Specialized COMO Manual De Instrucciones página 14

MINIMUM INSERTION (A)
The seatpost must be inserted into the frame deep enough so the minimum insertion/
maximum extension (min/max) mark (C) on the seatpost is not visible. The frame requires a
minimum of 80 mm of insertion (A).
MAXIMUM INSERTION (B)
The seat tube is reamed to a specified maximum insertion depth for each frame size. This
ream depth limits the insertion depth of the seatpost. Please refer to the table under Fig. 7.1.
If the desired seat height cannot be achieved within the minimum and maximum insertion
requirements, the seatpost should be replaced with a shorter or longer one.
Once the saddle height is determined, torque the supplied seatpost collar bolt to 6.2 Nm / 55 in-lbf.
TECH TIP: The specified ream depths are listed in the table under Fig. 7.1.
The tolerance of the ream depth can vary from frame to frame. Install a
regular 34.9 seat post in the seat tube to verify the actual ream depth of the
frame.
WARNING! Failure to follow the seat post and frame insertion requirements
may result in damage to the frame and/or seat post, which could cause you
to lose control and fall.
If the seat post is cut short, the min/max mark on the seat post may no
longer be accurate. Before cutting the seat post, note the min/max depth
required by the seat post manufacturer.
WARNING! For general instructions regarding the installation of the seat
post, refer to the appropriate section in the Owner's Manual. Riding with an
improperly tightened seat post can allow the saddle and seat post to slide
down, which can damage the frame and cause you to lose control and fall.
WARNING! Inspect the seat post and seat tube to ensure that there are
no burrs or sharp edges. Remove any burrs or sharp edges using fine-grit
sandpaper.
7. 3. D E RA I L LEUR/D RO PO UT H ANG ER
Non-enviolo Internal Geared Hub (IGH) equipped Como models are fitted with an Amazinger
2.1 derailleur hanger mounted directly at the rear dropout.
enviolo IGH equipped Como models have left and right adjustable sliding dropout hangers to
which the enviolo internal geared hub is mounted. These dropout hangers control the tension
of the belt and the alignment of the rear wheel.
INFO: Non-enviolo IGH equipped Como models are not compatible with an
enviolo IGH.
7.4. SPE ED S ENS OR
The Como is equipped with a speed sensor magnet, located on the rear hub/disc rotor
interface with either a 6 bolt rotor mounted (A) or a Centerlock
Dirt and/or metal debris may accumulate on the speed sensor magnet. Too much
accumulation may result in interruptions in motor support and/or inaccurate speed readings.
Regularly check your Speed Sensor magnet for an accumulation of dirt and/or metal debris, and
clean accordingly (A-B). The frequency of the cleaning depends on your riding conditions, ride
frequency, and/or brake pad material. Removing metal debris may require the use of a magnet
stronger than the speed sensor magnet.
7.2 a
WARNING! Be sure not to touch the speed sensor magnet while the wheel is
in motion. Also, the brake rotors may be extremely hot after riding.
(B) mounted version.
TM
7.2 b
12