Specialized COMO Manual De Instrucciones página 42

ADJUST THE SLIDING DROPOUT
12.10
Fig. 12.10
Loosen the sliding dropout locking bolts on both left and right rear dropouts (A).
„
Starting on the drive side (right), use a 3 mm hex key to tighten or loosen the adjuster bolt
„
to achieve the correct belt tension (B).
ALIGN THE REAR WHEEL
12.11
Fig. 12.11
Adjust the non-drive side adjuster bolt until the wheel is properly centered between the
„
chainstays.
Double-check the belt tension is still accurate and adjust if necessary.
„
Once the correct tension and alignment are achieved, torque the mounting bolts to 13 Nm /
„
115 in-lbf with a TX 30 wrench.
INFO: Proper belt tension is important. Too little tension can lead to tooth
jump or skipping. Too much tension can cause wear and damage. There are
several tools to ensure the best tension and the smoothest ride. For more
information on belt installation, use, and maintenance, please refer to
GatesCarbonDrive.com/OwnersManual.
www.
40