Specialized COMO Manual De Instrucciones página 17

7. 8 . I N T E G RAT E D H A N D L E BAR
The Como is equipped with a custom designed handlebar assembly which is setup differently
to other handlebars.
7.6
E
Fig. 7.6
When assembling the handlebar (A), secure the handlebar with the top cap and bolt (B)
„
first and then the steerer clamp (C). The steerer clamp is located behind a cover (D) on the
inside of the handlebar stem.
Align the holes in the top cap in line with the center of the bicycle (E).
„
Firmly seat the handlebar against the headtube before hand-tightening the top cap bolt
„
(B) using a 5 mm hex key. Make sure there is no play between the integrated handlebar,
handlebar spacer (F), and the headtube.
Using a T25 Torx key, lightly tighten the steerer clamp bolts (C) in an alternating pattern
„
until there are equal gaps on the clamp's left and right side, then torque the bolts in an
alternating pattern to 6.2 Nm / 55 in-lbf.
15
7.9. MASTER MI ND TCD -w MOUNTI NG BRACK ET
The MasterMind TCD-w is permanently fitted to the bicycle and secured to the twist-lock
mount with a security screw. Removal of the display will require the removal of the entire
mounting bracket from the integrated handlebar.
7.7
B
I
A
C
F
D
Fig. 7.7
Align the base plate (A) with the top cap (B) and insert the mounting screw (C) into the rear
„
hole. Hand-tighten the screw using a 3 mm hex key.
Twist the adjustable base plate (D) into the base plate and insert the mounting screw (E)
„
through the forward hole. Hand-tighten the screw using a 3 mm hex key.
Twist the MasterMind TCD-w (F) into the twist-lock mount (G) and insert the security screw
„
(H) into the mount to prevent the MasterMind TCD-w from being removed. Hand-tighten
the screw using a Philips head screwdriver.
Insert the MasterMind TCD-w and twist-lock mount assembly into the adjustable base
„
plate. Insert the mounting screw (I) through the hole, then hand-tighten with a 3 mm hex key.
F
G
H
E
D
C
A
B