Publicidad
Idiomas disponibles
Idiomas disponibles
3
Multimeter Features
Recording Measurement Data (Data Logging)
The Data Logging function provides you the convenience of recording test data for
future review or analysis. Since data is stored in the nonvolatile memory, the data
remains saved even when the multimeter is turned OFF or if the battery is
replaced.
The Data Logging feature collects measurement information over a user-specified
duration. There are four data logging options that can be used to capture
measurement data: manual (
– A manual log stores an instance of the measured signal each time
– An interval log stores a record of the measured signal at a user-specified
– An event log stores a record of the measured signal each time a trigger
– An export log stores a record of the measured signal and exports it via the
Table 3-1
Data logging option
Export (
Manual (
Interval (
Event (
Before starting a recording session, set up the multimeter for the measurements
to be recorded.
To change the data logging option, refer to "Changing the record ing option" on
page 124.
104
pressed for > 1 second. See page 105.
interval. See page 106.
condition is satisfied. See page 107.
multimeter's optical communication port each time
page 109.
Data logging maximum capacity
)
)
)
)
), interval (
), event (
Maximum capacity for saving
100
100
2000
Shares the same memory with Interval logging
Keysight U1241C/U1242C User's Guide
), or export (
Log
Hold
Log
is pressed. See
Hold
).
is
Publicidad
