Keysight Technologies U1241C Guia Del Usuario página 30

1 Introduction
This warning is intended to stop you from attempting to measure voltage,
continuity, resistance, capacitance, diode, or temperature values when the leads
are plugged into a current terminal.
When the rotary switch is set to the current measurement position but no lead is
inserted into its respective input terminal, the multimeter emits a continuous beep
and the red LED indicator lights up. The secondary display will show
the warning alert will stop after 3 seconds approximately.
Figure 1-3
Adjusting the tilt stand
To adjust the multimeter to a 60° standing position, pull the tilt stand outward to
its maximum reach.
Figure 1-4
30
LEAd input warning display
Pull until maximum reach
Tilt-stand adjustment and IR-USB cable connection
To PC (host)
IR-USB cable
Keysight U1241C/U1242C User's Guide
, and