Publicidad
Idiomas disponibles
Idiomas disponibles
Measuring AC or DC mV
You can set the multimeter to measure AC or DC mV at the following rotary switch
position (you must first enable the mV measurement function from the Setup
menu. Refer to "Changing the thermocouple type or setting the mV
measurement" on page 126.).
When this Setup item is enabled, the original temperature functions offered in
NOTE
this rotary switch position are disabled and replaced by AC or DC mV
measurements.
Table 2-4
[a] U1242C only.
It is recommended to use the mV function when measuring low voltages.
NOTE
Set up your multimeter to measure voltage as shown in Figure 2-2 or Figure 2-5.
Probe the test points and read the display.
Keysight U1241C/U1242C User's Guide
Rotary switch position allowing AC or DC mV measurements
Legend
Defaul t function
DC mV
1
2
Making Measurements
View
Function when
is pressed
Shift
Esc
Cycles between
– AC mV (true rms)
– AC mV (averaging sense)
– DC mV
2
[a]
, or
59
Publicidad
