Publicidad
Idiomas disponibles
Idiomas disponibles
6.3.2 SEMI – AUTOMATIC CYCLE WITH CONSISTENCY CONTROL.
(only for experts)
Fig.1
Fig.2
Fig.3
Fig.4
17 - ENGLISH
-
Press the SEMIAUTOMATICO (SEMI-
AUTOMATIC) key to select the semi-
automatic
batch
consistency control (Fig. 1).
-
The LEDs of the UP (▲),Conferma
(Confirm) (◄►) and DOWN (▼) keys light
up and
the numbers relative to the
consistency setting to be configured,
expressed by a numerical value between
60 and 250, appear on the display: press
the "UP (▲)" and "DOWN (▼)" keys to
increase or decrease this value (Fig. 2).
Higher consistencies correspond to high
numbers, lower consistencies correspond
to low numbers.
The maximum programmable consistency
value is equal to 250 numbers but not all
mixtures and not all quantities can reach
such a high consistency value.
For a reduced amount of mixture it is
recommended to not select consistency
numbers close to 250.
-
Subsequently,
(Confirm) (◄►) key to start a new batch
freezing cycle.
-
The SAC message is viewed on the
display for a few seconds to confirm the
semi-automatic cycle has been selected
(Fig.
3);
subsequently,
freezing, the instantaneous consistency
numerical value is displayed.(Fig. 4).
-
After a few minutes and once the
consistency level selected during the
programming phase has been reached, an
intermittent acoustic signal warns the
operator that it is possible to extract the ice
cream (Fig. 5). If this should not be
immediately possible, the machine will
automatically see to maintain the ice
freezing
cycle
press
the
Conferma
during
with
batch
Publicidad
