Frigomat TITAN 1 Manual De Uso Y Mantenimiento página 69

8.2 TROUBLESHOOTING
PROBLEM
The machine does not start
(STOP button off).
The machine works
intermittently during cooling.
The machine works properly
but the product is too firm.
The machine works properly
but the product is not firm
enough.
During batch freezing the
machine becomes noisy and
the beater stops.
During product extraction the
machine becomes noisy.
Presence of liquid ice cream
in the drip drawer.
PROBABLE CAUSES
Master switch open.
Electrical anomaly.
Fuses blown.
Air-cooled machines: air condenser
dirty or fan faulty.
Water-cooled machines: no
condensation water.
Unbalanced mixture or too little
introduced.
Work program selection incorrect.
Unbalanced mixture or too much
introduced.
Work program selection incorrect.
Beater scrapers worn.
Insufficient condensation.
Refrigeration system anomaly.
The belts slip.
Excessive hardening of the product.
Beater gasket absent or worn.
REMEDIES
Close the switch.
Contact the technician.
Contact the technician.
Clean the condenser with a brush,
check functioning of the fan and
the installation conditions on page
9.
Make sure there is water in the
water system to which the machine
is connected. Check the pipes and
cocks.
Check that the amount of mixture
introduced is correct and that it is
balanced properly.
Select a suitable work program
for the product one wishes to
achieve.
Check that the amount of mixture
introduced is correct and that it is
balanced properly.
Select a suitable work program
for the product one wishes to
achieve.
Check them and replace if
necessary.
Check the installation conditions
and that the temperature where
the machine is installed does not
exceed 35°C.
Contact the technician.
Contact the technician to check
the belts tension and possibly
replace them.
Make sure you have pressed the
"Estrazione" ("Extraction") key
before emptying the cylinder.
Check the presence of the
gasket and that it is not
excessively worn.
ENGLISH - 34