Frigomat TITAN 1 Manual De Uso Y Mantenimiento página 64

7.3 EXTRAORDINARY MAINTENANCE (INTENDED FOR QUALIFIED PERSONNEL)
These operations are reserved exclusively for authorised qualified personnel. FRIGOMAT
S.r.l. will not be held liable for damage to objects or harm to persons which occur due to
failure to comply with the above.
Refer to the following instructions to program the circuit board:
Fig.1
Fig.2
Fig.3
.
Fig.4
Fig.5
29 - ENGLISH
1. Make sure that the door is closed and the
safety grid is lowered.
2. Power the machine.
3. With the machine
"AGITAZIONE
"AUTOMATICO
simultaneously and release them only after
the password identification screen appears
(Fig. 1).
4. Press the "AGITAZIONE (MIXING) (▲)",
"AUTOMATICO
"ESTRAZIONE
keys simultaneously
password and then confirm it.(Fig. 2). If you
do not know the password, contact the
Frigomat assistance service.
5. When the password has been accepted,
the screen
programming steps
programming step
automatically (Fig. 3).
6. If you do not wish to change the value of
the selected step, press "AGITAZIONE
(MIXING) (▲)" to directly access the
following step (Fig. 4).
7. If, instead, you wish to change the selected
step, press "ESTRAZIONE (EXTRACTION)
(◄►)" to access the parameters relative to
the same step, and subsequently press
"AGITAZIONE
"AUTOMATICO
increase or
Subsequently, press the "ESTRAZIONE
(EXTRACTION) (◄►)" key to confirm the
data.
8. To exit programming and save the changes
press the "STOP" key (Fig. 5).
at STOP,
(MIXING)"
(AUTOMATIC)"
(AUTOMATIC)"
(EXTRACTION)
to type in
accesses the list
directly. The
is selected
P01
(MIXING) (▲)"
(AUTOMATIC)"
decrease the
press
and
and
(◄►)"
the
of
first
or
to
value.