Performing Threading; How To Use The Counter - JUKI MEB-3200 Manual De Instrucciones

(5) Performing threading

WARNING :
Turn OFF the power after operation of steps 1) and 2), and replace needle, thread, cloth cutting
knife or knife holder.
3

(6) How to use the counter


2
1
4
4
2
3
1
1) Press [THREAD
lghts up and the sewng machne stops at the settng
poston.
1 The needle bar rotates by 180˚ and threading
can be performed from the front sde.
2 The presser comes down.
3 Change the cloth set poston (memory swtch
No.11=1), and the presser (feed base) moves to
the rear (orgn poston) when the front set s used.
4 The cloth cuttng drve motor s turned to OFF,
and the cloth cuttng dal can be turned by hand.
5 Dsplay s shown as
In this state, keys other than [THREAD
key 1 and [RESET
accepted.
2) Press agan [THREAD
bar only returns to ts home poston.
3) Press [RESET ] key 4 and 1 to 5 return to
ther home postons.
The presser and the feed base operate.
Be careful that hands or fingers are not
being caught in them.
It is recommended to perform installing/removing
the presser unit after operating the aforementioned
step 1) and turning OFF the power.
The counter has been set to UP counter in
the state of delivery.
1) Press [COUNTER
value.
2) Every tme the sewng machne completes one
cycle sttchng, the value ncreases by 1 count.
3) The counter value can be changed wth [RIGHT
] key 2 or [RIGHT
4) Press [RESET ] key 4 to return the counter
value to "0".
The counter can be used as DOWN counter
as well.
(Refer to the item "10. Various functions : (6)
Change-over of the counter" P.43.)
] key 1 when sewng LED 3
2 .
] key 4 cannot be
] key 1 and the needle
] key 1 to dsplay the counter
] key 3 .
]