marposs TESTAR Quick read M Manual De Instalacion Y Uso página 199

Select Dynamic Type Measure of (Maximum – Minimum)/2.
The QuickRead checks and selects dynamic type measure of (maximum – minimum)/2 and
returns  .
In case of error QuickRead returns the string ERR3
The QuickRead display a NAN value how digital number and the bargraph is off.
DCYCL
Request from Host
Response from QuickRead
Start/Stop for Dynamic Cycle of Selected Measure.
The QuickRead checks and performs the start/stop for dynamic cycle of selected measure
and returns  .
In case of error QuickRead returns the string ERR3
If is a start command the QuickRead display the current value of dynamic measure
otherwise if is a stop command the QuickRead is frozen on the last value of dynamic
measure.
DSTOP
Request from Host
Response from QuickRead
Stop for Any Dynamic Measure Cycle.
The QuickRead checks and performs the stop for any dynamic measure cycle, leaves
dynamic mode and returns  .
In case of error QuickRead returns the string ERR3
The QuickRead display the value of static measure.
H
Request from Host
Response from QuickRead
Start/Stop for Hold Cycle.
The QuickRead checks and performs the start/stop for hold cycle and returns  .
In case of error QuickRead returns the string ERR3
st
On 1 command (Start), the QuickRead is frozen on the last value of static measure.
nd
On 2 command (Stop), the QuickRead display the static value of measure and so on.
DSTAR
Request from Host
Response from QuickRead
Select Dynamic Type Measure or Start/Stop for Hold Cycle.
The QuickRead checks and selects dynamic type measure or performs the start/stop for
hold cycle depending on its programming and returns  .
In case of error QuickRead returns the string ERR3
If "dynamic" mode is programmed the QuickRead enters on dynamic measure select mode.
If "hold" mode is programmed the QuickRead enters on hold cycle mode.
ASCII SERIAL TRANSMISSION PROTOCOL
 .
DCYCL
.
DSTOP
 .
 .
DSTAR
 .





H



199