marposs TESTAR Quick read M Manual De Instalacion Y Uso página 44

ENGLISH
NOTE 1:
The message "ALARM 80" is displayed by pressing PROG if Quick Read is in "SET-UP" mode
instead of measuring mode.
Press SETUP to return to measuring mode.
NOTE 2:
The information on the digital display may be upside-down depending on how the unit has
been positioned on the support base.
Enter the programming mode and reprogram the variable DIGITDIR.
In programming mode the keyboard allows to carry out different functions when moving in the
main or in the secondary menu respectively (see page 45, 46 e 47).
MAIN MENU (programming variables PROBE, M.UNIT, M.RANGE, SET N.VA, M.RESOL.,
UpperTOL, LowerTOL, MASTER, etc.)

entering the secondary menu of the choices/values relevant to the variable
ENTER
 
shift to the previous or to the next programming variable
- +
ESC
exit from programming saving the programmed data

SECONDARY MENU (choices/values relevant to each programming variable)
 
choice of the variable configuration or increase/decrease of its value with fast
- +
autorepeat

confirmation of the modified choice/value and shift to the next programming
ENTER
variable
exit from the secondary menu without confirmation of the modified choice/value
ESC

and shift to the next programming variable.
44