marposs TESTAR Quick read M Manual De Instalacion Y Uso página 43

I
3.2 Programming
The keyboard
allows to program the following variables appearing on the display:
VARIABLE
PASS SET
PROBE
M.UNIT
M.RANGE
SET N.VA
M.RESOL
UpperTOL
LowerTOL
MASTER
M. TYPE
SCALE
PreTRAV1
PreTRAV2
K1
K2
BAR SET
BARGRAPH
DIGITSET
DIGITDIR
SYST. ID
COM.MODE
Qrbin. / ASCII
i/o dyn.
i/o zero
BAUD
PARITY
STR. END
Press PROG for two seconds to enter the programming mode from measuring mode.
ESC PROG SETUP ZERO
DYN ENTER
Enabling the protection of the programming
Number of sensors to be connected
Measuring unit
Measuring range
Nominal value of the measure
Digital display resolution.
This variable appears only if M.RANGE = ± 0,250 / ± 0,500 / ± 1,000
mm (± .010" / ± .020" / ± .040") and SET N.VA = 0.
Upper tolerance limit
Lower tolerance limit
Master deviation
Measurement type
Analog display scale range (full scale)
Pretravel check on sensor 1
Pretravel check on sensor 2 (this variable is displayed only if the
connection of two sensors has been programmed)
Multiplying coefficient of the transducer signal of the sensor 1
Multiplying coefficient of the transducer signal of the sensor 2 (this
variable is displayed only if the connection of two sensors has been
programmed)
Analog visualization on/off
Direction of measurement analog visualization
Digital display on/off
Reading direction of the digital display
Software identification number for serial transmission of the data to PC,
data collectors, BCD interface, PLC.
Type of protocol for serial data transmission or connection to the Quick
Read pushbutton box (remote zeroing, dynamic acquisition, send mode).
Enabling dynamic measuring mode for acquisitions made by means of
the Quick Read footswitch
Enabling remote zeroing by means of the Quick Read footswitch or a
customer's push-button
Baud rate: data transmission speed
Parity bit + data bit + stop bit
String end
_
+
DESCRIPTION
Chapter 3. Installation 43