marposs TESTAR Quick read M Manual De Instalacion Y Uso página 45

I
MAIN
MENU
( continue ...)
START PROGRAMMING
(Press PROG for TWO SECONDS)
Tabella 4
SECONDARY
MENU
CHOICE
CHOICE
CHOICE
CHOICE
VALUE
CHOICE
VALUE
Up to ±10,000
according to
programmed value
M.RANGE.
VALUE
Up to ±10,000
according to
programmed value
M.RANGE.
VALUE
Choice to protect the programming.
Choice of the number of sensors to be
connected.
Choice of the measuring unit.
Choice of the measuring range.
Programming of the nominal value of the
measurement (to display its absolute value).
In this case the displayed measurement
value has a default resolution of 0,001 mm
Choice of the digital display resolution (this
variable appears only if M.RANGE = ±
0,250 / ± 0,500 / ± 1,000 mm and SET N.VA
= 0,000. If M.RANGE = ± 2,500 / ± 5,000
mm and/or SET N.VA different from 0, the
resolution has a default value of 0,001 mm).
Programming of the upper tolerance limit. If
M.RESOL = high, the value is programmed
mm
with 0,0001 mm resolution. If M.RESOL =
the
low, the value
of
0,001 mm resolution.
Programming of the lower tolerance limit. If
M.RESOL = high, the value is programmed
mm
with 0,0001 mm resolution. If M.RESOL =
the
low, the value
of
0,001 mm resolution.
Programming of the master deviation. If
M.RESOL = high the value is programmed
with 0,0001 mm resolution. If M.RESOL =
low the value is programmed with 0,001 mm
resolution.
Chapter 3. Installation
is programmed with
is programmed with
45